Navegar

Colección

Datos Estadísticas

Artículo

Estamos trabajando para incorporar este artículo al repositorio
Consulte el artículo en la página del editor
Consulte la política de Acceso Abierto del editor

Abstract:

Austenitic stainless steels are the preferred materials for mechanical components in the food, oil and chemical industries due to their good corrosion resistance but they often suffer severe wear due to their poor tribological properties. Plasma surface engineering has been extended to stainless steel hardening, through the modification of the surface with ion nitriding or the application of hard coatings. In this work, AISI 316L samples were coated with titanium nitride by means of a cathodic arc (CA) and this technique was combined with plasma immersion ion implantation, in a process called plasma based ion implantation and deposition (PBII&D). The effect on corrosion resistance was analyzed, also considering ion nitriding as a pre-treatment. Microstructure and composition were analyzed by means of glancing angle XRD, SIMS, SEM, SEM-FIB and EDS. Localized corrosion resistance was analyzed in a cyclic potentiodynamic polarization experiment in 3.5% NaCl solution, and the corroded surface was analyzed with AFM, SEM and EDS as well. It was found that nitriding at 400 °C produces a thin nitrided layer with good corrosion resistance. A duplex TiN coating resulted in a further improvement of the corrosion resistance. Comparing cathodic arc and PBII&D coating techniques, the last one gives the thickest film and also the best corrosion behavior with good adhesion. © 2013 Elsevier B.V.

Registro:

Documento: Artículo
Título:Microstructure and corrosion behavior of AISI 316L duplex treated by means of ion nitriding and plasma based ion implantation and deposition
Autor:Escalada, L.; Lutz, J.; Brühl, S.P.; Fazio, M.; Márquez, A.; Mändl, S.; Manova, D.; Simison, S.N.
Filiación:Corrosion Division, INTEMA, Faculty of Engineering, University of Mar del Plata, Juan B. Justo 4302, Mar del Plata, Argentina
Leibniz Institute of Surface Modification (IOM), Permoserstr, 15, 04318 Leipzig, Germany
Surface Engineering Group, Universidad Tecnológica Nacional (UTN-FRCU), Ing. Pereira 676, E3264BTD Concepción del Uruguay, Argentina
INFIP (CONICET-University of Buenos Aires), Ciudad Universitaria, Pab. 1, 1428 Ciudad de Buenos Aires, Argentina
Palabras clave:Corrosion resistance; Plasma ion implantation; Plasma nitriding; TiN coating; Cyclic potentiodynamic polarization; Localized corrosion resistances; Plasma based ion implantation and deposition; Plasma immersion ion implantation; Plasma ion implantation; Plasma nitriding; TiN coating; Tribological properties; Austenitic stainless steel; Chemical industry; Corrosive effects; Deposition; Hard coatings; Ion implantation; Ions; Microstructure; Nitriding; Oils and fats; Plasma deposition; Plasmas; Titanium nitride; Corrosion resistance
Año:2013
Volumen:223
Página de inicio:41
Página de fin:46
DOI: http://dx.doi.org/10.1016/j.surfcoat.2013.02.025
Título revista:Surface and Coatings Technology
Título revista abreviado:Surf. Coat. Technol.
ISSN:02578972
Registro:https://bibliotecadigital.exactas.uba.ar/collection/paper/document/paper_02578972_v223_n_p41_Escalada

Referencias:

  • Escalada, L., Lutz, J., Mändl, S., Manova, D., Neumann, H., Simison, S., (2012) Surf. Coat. Technol., 211, p. 76
  • Mingolo, N., Tschiptschin, A.P., Pinedo, C.E., (2006) Surf. Coat. Technol., 201, p. 4215
  • Gil, L., Brühl, S., Jiménez, L., Leon, O., Guevara, R., Staia, M.H., (2008) Surf. Coat. Technol., 202, p. 1802
  • Li, X., Bell, T., (2008) Corros. Sci., 46, p. 1527
  • Manova, D., Thorwarth, G., Mändl, S., Neumann, H., Stritzker, B., Rauschenbach, B., (2006) Nucl. Instr. Meth. B, 242, p. 285
  • Nosei, L., Avalos, M., Gómez, B.J., Nachez, L., Feugeas, J., (2004) Thin Solid Films, 468, p. 134
  • Fossati, A., Borgioli, F., Galvanetto, E., Bacci, T., (2006) Corros. Sci., 48, p. 1513
  • Gontijo, L.C., Machado, R., Miola, E.J., Casteletti, L.C., Alcântara, N.G., Nascente, P.A.P., (2006) Mater. Sci. Eng., 431, p. 315
  • Choy, K.L., (2003) Prog. Mater. Sci., 48, p. 57
  • Rodríguez, R.J., García, J.A., Medrano, A., Rico, M., Sánchez, R., Martínez, R., Labrugère, C., Guette, A., (2002) Vacuum, 67, p. 559
  • Puchi-Cabrera, E.S., Martínez, F., Herrera, I., Berríos, J.A., Dixit, S., Bhat, D., (2004) Surf. Coat. Technol., 182, p. 276
  • Matthews, A., Leyland, A., Wilson, A., (2002) Vacuum, 68, p. 57
  • Smolik, J., Walkowicz, J., Tacikowski, J., (2000) Surf. Coat. Technol., 125, p. 134
  • Dong, H., Sun, Y., Bell, T., (1997) Surf. Coat. Technol., 90, p. 91
  • Wu, W., Li, X., Chen, J., Dong, H., (2009) Surf. Coat. Technol., 203, p. 1273
  • Short, K.T., Zhang, Z., Finnie, K., Collins, G.A., Figueroa, C.A., (2008) Mater. Lett., 62, p. 3156
  • Liu, C., Lin, G., Yang, D., Qi, M., (2006) Surf. Coat. Technol., 200, p. 4011
  • Chenglong, L., Dazhi, Y., Guoqiang, L., Min, Q., (2005) Mater. Lett., 59, p. 3813
  • Anders, A., (2004) Surf. Coat. Technol., 183, p. 301
  • Bilek, M.M., McKenzie, D.R., Tarrant, R.N., Lim, S.H.M., McCulloch, D.G., (2002) Surf. Coat. Technol., 156, p. 136
  • Attenberger, W., Thorwarth, G., Manova, D., Mändl, S., Strizker, B., Rauschenbach, B., (2004) Surf. Coat. Technol., p. 412
  • Arias Duran, A., Fazio, M., Kleiman, A., Giuliani, L., Márquez, A., Grondona, D., Study of the efficiency of magnetic island macroparticle filters for different vacuum arc configurations (2012) Journal of Physics: Conference Series, 370, p. 012016
  • Lim, S.H.N., McCulloch, D.G., Russo, S., Bilek, M.M.M., McKenzie, D.R., (2002) Nucl. Instr. Meth. B, 190, p. 723
  • Huber, P., Manova, D., Mändl, S., Rauschenbach, B., (2003) Surf. Coat. Technol., p. 1243
  • Wan, G.J., Huang, N., Leng, Y.X., Yang, P., Chen, J.Y., Wang, J., Sun, H., (2004) Surf. Coat. Technol., 186, p. 136
  • Kelly, H., Lepone, F.A., Márquez, A., (2001) J. Appl. Phys., 89, p. 1567
  • Sosa, A.D., Echeverría, M.D., Moncada, O.J., Simison, S.N., (2008) Mater. Lett., 62, p. 100
  • Brühl, S.P., Charadia, R., Simison, S., Lamas, D.G., Cabo, A., (2010) Surf. Coat. Technol., 204, p. 3280
  • Yongqiang, W., Xiaoxia, C., Xiubo, T., Chunzhi, G., Shiqin, Y., Zhiqiang, J., Liangji, C., (2013) Vacuum, 89, p. 185
  • (1995) Handbook of Vacuum Arc Science and Technology, Fundamentals and Applications, , Noyes, Park Ridge, NJ, R.L. Boxman, D.M. Sanders, P.J. Martin (Eds.)
  • (2004) Handbook of Plasma Immersion Ion Implantation and Deposition, p. 243. , Wiley-VCH, Weinheim, A. Anders (Ed.)
  • Vieira, R., Nono, M.C.A., (2005) Mater. Sci. Forum, p. 717
  • Ziegler, J.F., http://www.srim.org

Citas:

---------- APA ----------
Escalada, L., Lutz, J., Brühl, S.P., Fazio, M., Márquez, A., Mändl, S., Manova, D.,..., Simison, S.N. (2013) . Microstructure and corrosion behavior of AISI 316L duplex treated by means of ion nitriding and plasma based ion implantation and deposition. Surface and Coatings Technology, 223, 41-46.
http://dx.doi.org/10.1016/j.surfcoat.2013.02.025
---------- CHICAGO ----------
Escalada, L., Lutz, J., Brühl, S.P., Fazio, M., Márquez, A., Mändl, S., et al. "Microstructure and corrosion behavior of AISI 316L duplex treated by means of ion nitriding and plasma based ion implantation and deposition" . Surface and Coatings Technology 223 (2013) : 41-46.
http://dx.doi.org/10.1016/j.surfcoat.2013.02.025
---------- MLA ----------
Escalada, L., Lutz, J., Brühl, S.P., Fazio, M., Márquez, A., Mändl, S., et al. "Microstructure and corrosion behavior of AISI 316L duplex treated by means of ion nitriding and plasma based ion implantation and deposition" . Surface and Coatings Technology, vol. 223, 2013, pp. 41-46.
http://dx.doi.org/10.1016/j.surfcoat.2013.02.025
---------- VANCOUVER ----------
Escalada, L., Lutz, J., Brühl, S.P., Fazio, M., Márquez, A., Mändl, S., et al. Microstructure and corrosion behavior of AISI 316L duplex treated by means of ion nitriding and plasma based ion implantation and deposition. Surf. Coat. Technol. 2013;223:41-46.
http://dx.doi.org/10.1016/j.surfcoat.2013.02.025